User Manual

RcvErrors:.......................0
RcvRemotePhysErrors:.............0
RcvSwRelayErrors:................0
XmtDiscards:.....................3
XmtConstraintErrors:.............0
RcvConstraintErrors:.............0
LinkIntegrityErrors:.............0
ExcBufOverrunErrors:.............0
VL15Dropped:.....................0
XmtData:.........................0
RcvData:.........................0
XmtPkts:.........................0
RcvPkts:.........................0
Rev 4.70
Mellanox Technologies
117
14.3.8 ibping
ibping uses vendor MADs to validate connectivity between IB nodes. On exit, (IP) ping like out-
put is shown. ibping is run as client/server, however the default is to run it as a client. Note also
that in addition to ibping, a default server is implemented within the kernel.
14.3.8.1 ibping Synopsis
ibping [-d(ebug)] [-e(rr_show)] [-v(erbose)] [-G(uid)] [-C ca_name] [-P ca_port]
[-s smlid] [-t(imeout)timeout_ms] [-V(ersion)] [-L(id)][-u(sage)] [-c ping_count] [-
f(lood)] [-o oui] [-S(erver)] [-h(elp)] <dest lid | guid>
14.3.8.2 ibping Options
The table below lists the various flags of the command.
Table 21 - ibping Flags and Options
Flag Description
--count, -c <num> Stops after count packets
-f, (--flood) Floods destination: send packets back to back without delay
-o, (--oui) Uses specified OUI number to multiplex vendor mads
--Server, -S Starts in server mode (do not return)
--debug, -d/-ddd/ -d -d -d Raises the IB debugging level
--errors, -e Shows send and receive errors (timeouts and others)
--help, -h Shows the usage message
--verbose, -v/-vvv/-v -v -v Increases the application verbosity level
--version, -V Shows the version info
--Lid, -L Use LID address argument
--usage, -u Usage message