User Guide

1-4

Chapter 1: Product introduction

1.5 Replacing the card bracket

ThePEI-10G/82599-2SEthernetcardisbundledwithafull-lengthbracket,alow-prole

bracket, and an ASUS proprietary bracket. By default, the card is pre-installed with a full-

length bracket.

TheproprietraybracketsupportsASUSZ10PH-D16series,ESC4000G3series,and

RS720Q-E8seriesmodels,etc.Thesupportedlistofmodelsaresubjecttochangewithout

prior notice.

To replace the card bracket:

1. Get the

PEI-10G/82599-2SEthernetcardandplaceitonastableandatsurface.

Ensurethattheprintedcircuitboard(PCB)isfacingdown.

2. RemovethetwoscrewsthatsecuresthePEI-10G/82599-2SEthernetcardtothecard

bracket then remove the card bracket.

3. Getthereplacementcardbracket.

4. Align and insert the PEI-10G/82599-2S Ethernet card into the mounting hole of the card

bracket. Ensure that the screw holes on the PEI-10G/82599-2S Ethernet card matches

the screw holes of the card bracket.

5. Replacethescrewsthatyouremovedearlierinstep2.

Screw

Replacement card bracket

Default card bracket