User Guide

2-6
Chapter 2: Boot Agent Conguration
• When using iSCSI boot, set Boot to iSCSI Target to [Disabled] or [One Time Disabled].
• When using iSCSI boot to install Windows Server 2008 OS, refer to
http://support.microsoft.com/kb/974072/EN-US to complete the process.
DHCP Vendor ID [BRCM ISAN]
Controls how the iSCSI boot host software interprets the Vendor Class ID eld used in
the DHCP server. If DHCP is disabled, this value does not need to be specied. Enter
a new value in 0 to 32 characters.
Link Up Delay Time [0]
Decides how many seconds the iSCSI boot host software waits after an Ethernet link is
established before sending any data over the network. The valid values are 0 to 255.
Use TCP Timestamp [Disabled]
Enables or disables the TCP Timestamp option.
Conguration options: [Disabled] [Enabled]
Target as First HDD [Disabled]
When enabled, the iSCSI target drive appears as the rst hard drive in the system.
Conguration options: [Disabled] [Enabled]
LUN Busy Retry Count [0]
Species the number of connection retries the iSCSI Boot initiator will attempt if the
iSCSI target LUN is busy. Conguration options: [0] – [60]
IP Version [IPv4]
Switches between the IPv4 or IPv6 protocol.
Conguration options: [IPv4] [IPv6]
Modifying this parameter erases all IP-related values.