User Guide

1-4

Chapter 1: Product introduction

1.5 Replacing the card bracket

ThePEB-10G/57840-2TEthernetcardisbundledwithafull-lengthbracket,alow-prole

bracket, and an ASUS proprietary bracket. By default, the card is pre-installed with a full-

length bracket.

TheproprietraybracketsupportsASUSZ10PH-D16series,ESC4000G3series,and

RS720Q-E8seriesmodels,etc.Thesupportedlistofmodelsaresubjecttochangewithout

prior notice.

To replace the card bracket:

1. Get the

PEB-10G/57840-2TEthernetcardandplaceitonastableandatsurface.

Ensurethattheprintedcircuitboard(PCB)isfacingdown.

2. RemovethetwoscrewsthatsecuresthePEB-10G/57840-2TEthernetcardtothecard

bracket(A)thenremovethecardbracket(B).

3. Getthereplacementcardbracket.

4. Align and insert the PEB-10G/57840-2T Ethernet card into the mounting hole of the

card bracket. Ensure that the screw holes on the PEB-10G/57840-2T Ethernet card

matches the screw holes of the card bracket.

5. Secure the card with the screws that you removed earlier in step 2.

screw

replacement card bracket

default card bracket