User Guide

1-4

Chapter 1: Product introduction

1.5 Replacing the card bracket

ThePEB-10GSeriesEthernetcardisbundledwithafull-lengthbracket,alow-prolebracket,

and an ASUS proprietary bracket. By default, the card is pre-installed with a full-length

bracket.

The proprietray bracket supports ASUS Z10PH-D16 series, ES4000 G3 series, and

RS720Q-E8 series models, etc. The supported list of models are subject to change without

prior notice.

To replace the card bracket:

1. Get the

PEB-10GSeriesEthernetcardandplaceitonastableandatsurface.

Ensure that the printed circuit board (PCB) is facing down.

2. Remove the two screws that secures the PEB-10G Series Ethernet card to the card

bracket then remove the card bracket.

3. Get the replacement card bracket.

4. Align and insert the PEB-10G Series Ethernet card into the mounting hole of the card

bracket. Ensure that the screw holes on the PEB-10G Series Ethernet card matches

the screw holes of the card bracket.

5. Replace the screws that you removed earlier in step 2.

screw

replacement card bracket

default card bracket