User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Edge Computer
- Chapter 2: Using your Edge Computer
- Chapter 3: Upgrading your Edge Computer
- 3.1 Removing the side cover
- 3.2 Replacing the side cover
- 3.3 Installing memory modules
- 3.4 Installing an mPCIe / mSATA module
- 3.5 Installing an M.2 E key module
- 3.6 Installing an M.2 M key module
- 3.7 Installing a PCIe expansion card
- 3.8 Installing a storage device
- 3.9 Replacing the CMOS battery
- 3.10 (optional) Installing a nano SIM card
- 3.11 Installing a CFast card
- Appendix
32
PE400D Series
2.1 Getting started
2.1.1 (optional) Connect the AC power adapter to
your Edge Computer
If your Edge computer package comes bundled with a power adapter, you
may follow the steps below to set up your Edge computer using the power
adapter.
NOTE: This section depends on the availability of the power adapter.
The power adapter is optional and may not come bundled.
A. Connect the power cord to the AC power adapter.
B. Connect the power terminal block to power jack adapter to the AC
adapter.
C. Connect the power terminal block to power jack adapter to your Edge
Computer’s power (DC) input, then secure it with the two screws on the
power terminal block to power jack adapter cable.
D. Plug the AC power adapter into a 100V~240V power source.