User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Edge Computer
- Chapter 2: Using your Edge Computer
- Chapter 3: Upgrading your Edge Computer
- 3.1 Removing the side cover
- 3.2 Replacing the side cover
- 3.3 Installing memory modules
- 3.4 Installing an mPCIe / mSATA module
- 3.5 Installing an M.2 E key module
- 3.6 Installing an M.2 M key module
- 3.7 Installing a PCIe expansion card
- 3.8 Installing a storage device
- 3.9 Replacing the CMOS battery
- 3.10 (optional) Installing a nano SIM card
- 3.11 Installing a CFast card
- Appendix
22
PE400D Series
4. AT / ATX power selection
The AT_ATX_SEL jumper allows you to conīgure between AT or ATX
power mode. If the jumper is attached, ATX power mode is set, if the
jumper is removed, AT power mode will be set.
NOTE: The default setting for this jumper is set to ATX mode with a
jumper cap attached.