User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Edge Computer
- Chapter 2: Using your Edge Computer
- Chapter 3: Upgrading your Edge Computer
- 3.1 Removing the side cover
- 3.2 Replacing the side cover
- 3.3 Installing memory modules
- 3.4 Installing an mPCIe / mSATA module
- 3.5 Installing an M.2 E key module
- 3.6 Installing an M.2 M key module
- 3.7 Installing a PCIe expansion card
- 3.8 Installing a storage device
- 3.9 Replacing the CMOS battery
- 3.10 (optional) Installing a nano SIM card
- 3.11 Installing a CFast card
- Appendix
PE400D Series
21
3. Chassis Intrusion header
The Chassis Intrusion header allows you to connect a intrusion sensor
or microswitch for the chassis intrusion detection feature. When you
remove any chassis component, the sensor or microswitch triggers and
sends a high level signal and records a chassis intrusion event.
NOTE: The default setting for this jumper is set to Chassis intruder -
Close with a jumper cap attached.