User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Edge Computer
- Chapter 2: Using your Edge Computer
- Chapter 3: Upgrading your Edge Computer
- 3.1 Removing the side cover
- 3.2 Replacing the side cover
- 3.3 Installing memory modules
- 3.4 Installing an mPCIe / mSATA module
- 3.5 Installing an M.2 E key module
- 3.6 Installing an M.2 M key module
- 3.7 Installing a PCIe expansion card
- 3.8 Installing a storage device
- 3.9 Replacing the CMOS battery
- 3.10 (optional) Installing a nano SIM card
- 3.11 Installing a CFast card
- Appendix
16
PE400D Series
Dual-mode DisplayPort
The 20-pin DisplayPort 1.2 port can support resolutions up
to 4096 x 2304 @ 60 Hz on external display devices, and
supports DVI or HDMI™ adapters.
NOTE: Default 4096x2304 @60Hz and supports 3
independent displays at the same time.
Remote Power button connector
The bundled terminal block allows you to connect an external
power button for remotely powering your Edge Computer
on or o.
Power input
This power input jack allows you to connect the bundled
power terminal block to power jack adapter. Power supplied
through this jack supplies power to the Edge Computer.
Functional Earth Ground
The Functional Earth Ground provides you with a grounding
point.