User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Edge Computer
- Chapter 2: Using your Edge Computer
- Chapter 3: Upgrading your Edge Computer
- 3.1 Removing the side cover
- 3.2 Replacing the side cover
- 3.3 Installing memory modules
- 3.4 Installing an mPCIe / mSATA module
- 3.5 Installing an M.2 E key module
- 3.6 Installing an M.2 M key module
- 3.7 Installing a PCIe expansion card
- 3.8 Installing a storage device
- 3.9 Replacing the CMOS battery
- 3.10 (optional) Installing a nano SIM card
- 3.11 Installing a CFast card
- Appendix
PE400D Series
15
Serial (COM) connector
The 9-pin RS232/422/485/CANBUS serial (COM) connector
allows you to connect devices that have serial ports such as
bar code scanner, modem, or printers. Please refer to the table
below for the pin denitions of the dierent COM connectors.
NOTE: Default set to RS-232, can be congured to
CANBUS through the onboard jumper.
HDMI™ 1.4 port
The integrated 19-pin HDMI (High Denition Multimedia
Interface) port with a receptacle connector can support
resolutions up to 4096 x 2160 @ 30 Hz on external display
devices.
HDMI™ 2.0 port
The integrated 19-pin HDMI (High Denition Multimedia
Interface) port with a receptacle connector can support
resolutions up to 4096 x 2160 @ 60 Hz on external display
devices.
1 2 3 4 5
6 7 8 9
Pin RS-232 RS-422 RS485 CANBUS
1 DCD# TX- D- -
2 RXD TX+ D+ CAN_L
3 TXD RX+ NA CAN_H
4 DTR RX- NA -
5 GND GND GND -
6 DSR NA NA -
7 RTS NA NA -
8 CTS NA NA -
9 RI NA NA -