User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Edge Computer
- Chapter 2: Using your Edge Computer
- Chapter 3: Upgrading your Edge Computer
- 3.1 Removing the side cover
- 3.2 Replacing the side cover
- 3.3 Installing memory modules
- 3.4 Installing an mPCIe / mSATA module
- 3.5 Installing an M.2 E key module
- 3.6 Installing an M.2 M key module
- 3.7 Installing a PCIe expansion card
- 3.8 Installing a storage device
- 3.9 Replacing the CMOS battery
- 3.10 (optional) Installing a nano SIM card
- 3.11 Installing a CFast card
- Appendix
12
PE400D Series
LTE Wireless antenna jack
The LTE wireless antenna jack allows you to connect a
wireless antenna for LTE signals.
NOTE: The LTE wireless antenna is optional and may not
come bundled.
WLAN Wireless antenna jack
The WLAN wireless antenna jack allows you to connect a
wireless antenna for Wi-Fi signals.
NOTE: The WLAN wireless antenna is optional and may
not come bundled.
Microphone input jack
The microphone input jack is used to connect your Edge
Computer to an external microphone.
Audio output jack
This stereo audio jack is used to connect the system’s audio
out signal to amplied speakers.
Isolated DIO connector
The Isolated Digital Input/Output (DIO) connector provides
electrical isolation (up to 2500 VDC) of digital input and
output signals, which allow micro controllers to detect and
output logic states. The high voltage protection can be used
in industrial level uses. Please refer to the illustration below
for the pin denition of the Isolated DIO connector.
DI0H
DI0L
DI1H
DI1L
DI2H
DI2L
DI3H
DI3L
DO0H
DO0L
DO1H
DO1L
DO2H
DO2L
DO3H
Do3L