User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
57
3.11 Installing memory modules
Your Embedded Computer comes with two (2) SO-DIMM memory slots that
allow you to install DDR5 SO-DIMMs, ECC*, with a maximum of 64 GB.
To install a memory module:
1. Place the Embedded Computer on a at stable surface, with its top side
facing down.
2. Remove the twelve (12) screws securing the bottom heatink to the
chassis, and carefully ip and set the bottom heatsink aside.