User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
56
1. Follow the instructions in the Removing the heat spreader section to
remove the top heatsink and heat spreader.
2. (Optional) Remove the M.2 module from the M.2 B-key slot, if one is
installed, by first removing the screw securing the module, and then
removing the module.
3. Push the nano SIM cover in the direction shown in the illustration.
4. Lift the nano SIM cover.
5. Place the nano SIM into the nano SIM slot.
6. Close the nano SIM cover.
7. Push the nano SIM cover away from the storage bays to secure the
nano SIM card.
3.10 Installing a nano SIM card