User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
54
To install a CAN bus module:
1. Follow the instructions in the Removing the heat spreader section to
remove the top heatsink and heat spreader.
2. Remove the screw from the M.2 standoff.
3. Align and insert the module into the slot.
4. Gently press down, and then secure it in place using the screw
previously removed.
5. Identify the punch-out ports for COM3 and COM4 on the front of your
Embedded Computer (refer to the Front view section for the locations),
and detach the metal covers from them.
WARNING! Take extra care when removing the metal covers. Use tools,
such as a screw driver, to bend and remove the metal covers to avoid
physical injury.
6. Connect the ends of the CAN bus cables with the 4-pin female headers
to the 4-pin male headers on the CAN bus module.
7. Install the CAN bus ports by aligning and inserting them through the
punch-out ports as shown, and then securing them with the bundled
screws.
IMPORTANT! Ensure that the cable for the COM3 port is connected to
the corresponding COM3 header on the CAN bus module, and likewise,
the cable for the COM4 port is connected to the corresponding COM4
header.