User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
53
ANT.6ANT.5 ANT.3
ANT.5ANT.3
ANT.6
Ant. Jack Module Connector
ANT. 3 LTE_Main
ANT. 5 LTE_Aux
ANT. 6 LTE_GPS
NOTE:
• To enable the hot-plug function of your 4G LTE module, click the
weston-terminal icon in the upper left corner of your screen, and
type the first command below when prompted:
mm_cli sim-detect 1 (enable hot-plug function)
mm_cli sim-detect 0 (disable hot-plug function)
mm_cli sim-detect (display current setting)
• Connect ANT. 6 for GPS satellite tracking capability.
• Please refer to the Installing antennas section for more information
on installing the antennas.
• Connecting antennas to your module may strengthen the wireless
signal.
• A soft clicking sound indicates that the antenna has been securely
attached to the module.