User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
52
3.9 Installing an mPCIe / mSATA
module
Your Embedded Computer comes with a mini PCIe / mini SATA slot that
allows you to install a 4G LTE mPCIe module or a CAN bus module.
To install a 4G LTE mPCIe module:
WARNING! RF modules are intended for OEM or host integrators only.
For availability of system level RF certication, check with your OEM
integrator.
1. Follow the instructions in the Removing the heat spreader section to
remove the top heatsink and heat spreader.
2. Remove the screw from the M.2 standoff.
3. Align and insert the module into the slot.
4. Gently press down, and then secure it in place using the screw
previously removed.
5. (Optional) Connect the RF cables from the antennas to your module.
Make sure that the correct cable is attached to each of the connectors
by referring to the illustration on the next page.