User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
50
To install an M.2 4G LTE module:
1. Follow the instructions in the Removing the heat spreader section to
remove the top heatsink and heat spreader.
2. Remove the screw from the M.2 standoff.
3. If the stando is already seated in the right mounting hole to t your
M.2 module, skip to step 5.
4. Unscrew the stando and install it to a mounting hole that matches the
length of your M.2 module.
5. Align and insert the module into the slot.
6. Gently press down, and then secure it in place using the screw
previously removed.
7. (Optional) Connect the RF cables from the antennas to your module.
Make sure that the correct cable is attached to each of the connectors
by referring to the illustration on the next page.
NOTE:
• To enable the hot-plug function of your 4G LTE module, click the
weston-terminal icon in the upper left corner of your screen, and
type the first command below when prompted:
mm_cli sim-detect 1 (enable hot-plug function)
mm_cli sim-detect 0 (disable hot-plug function)
mm_cli sim-detect (display current setting)
• Connect ANT. 6 for GPS satellite tracking capability.
• Please refer to the Installing antennas section for more information
on installing the antennas.
• Connecting antennas to your module may strengthen the wireless
signal.
• A soft clicking sound indicates that the antenna has been securely
attached to the module.