User Manual

48
Your Embedded Computer comes with an M.2 (B-key, supports 3042/3052)
slot that allows you to install an M.2 5G/4G/UDR GPS module.
3.8 Installing an M.2 B-key module
To install an M.2 5G NR module:
1. Follow the instructions in the Removing the heat spreader section to
remove the top heatsink and heat spreader.
2. Remove the screw from the M.2 standoff.
3. If the stando is already seated in the right mounting hole to t your
M.2 module, skip to step 5.
4. Unscrew the stando and install it to a mounting hole that matches the
length of your M.2 module.
5. Align and insert the M.2 module into the slot.
6. Press down, and then secure it in place using the screw previously
removed.
7. (Optional) Connect the RF cables from the antennas to your module.
Make sure that the correct cable is attached to each of the connectors
by referring to the illustration on the next page.
WARNING! RF modules are intended for OEM or host integrators only.
For availability of system level RF certication, check with your OEM
integrator.
NOTE:
• Please refer to the Installing antennas section for more information
on installing the antennas.
• Connecting antennas to your module may strengthen the wireless
signal.
• A soft clicking sound indicates that the antenna has been securely
attached to the module.