User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
46
Your Embedded Computer comes with an M.2 (E-key) slot that allow you to
install an M.2 Wi-Fi module.
3.7 Installing an M.2 E-key module
To install an M.2 Wi-Fi module:
1. Follow the instructions in the Removing the heat spreader section to
remove the top heatsink and heat spreader.
2. Remove the screw from the M.2 stando.
3. Align and insert the module into its slot inside the Embedded
Computer.
4. Gently push down the module on top of the stando, and then fasten
it using the previously removed screw.
5. (Optional) Connect the RF cables from the antennas to your module.
Make sure that the correct cable is attached to each of the connectors
by referring to the illustration on the next page.
WARNING! RF modules are intended for OEM or host integrators only.
For availability of system level RF certication, check with your OEM
integrator.
NOTE:
• Please refer to the Installing antennas section for more information
on installing the antennas.
• Connecting antennas to your module may strengthen the wireless
signal.
• A soft clicking sound indicates that the antenna has been securely
attached to the module.