User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
45
3.6 Installing an M.2 M-key module
Your Embedded Computer comes with an M.2 (M-key) slot that allow you to
install an M.2 SSD (M-key, supports 2280 PCIe Gen 4 x4) module.
To install an M.2 SSD module:
1. Follow the instructions in the Removing the heat spreader section to
remove the top heatsink and heat spreader.
2. Align and insert the M.2 SSD into its slot inside the Embedded
Computer.
3. Gently push down the M.2 SSD on top of the stand screw hole, and
fasten it using a screw.