User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
43
3.5 Removing the heat spreader
1. Follow the instructions in the Removing the top heatsink section to
remove the top heatsink.
2. Follow steps 1-2 in the Installing a storage device section to remove the
storage device trays.
3. Remove the eight (8) screws securing the two (2) storage connector
brackets (A), and disconnect the SATA signal and power cables from the
motherboard (B).