User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
41
3.4 Installing an MXM GPU module
1. Remove the top heatsink. Refer to the Removing the top heatsink
section for detailed instructions.
2. Carefully remove the absorber from the carrier board.
Your Embedded Computer comes with an MXM GPU slot on the top
heatsink.
NOTE: The MXM GPU card is purchased separately.