User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
37
3.1 Installing a storage device
Your may install up to two (2) 2.5-inch storage devices (hot-swappable,
7~7.5mm) to your Embedded Computer.
1. Loosen the two (2) screws securing each of the storage device trays to
the right panel.
2. Pull the storage device tray out of the chassis.
3. Install your storage device to the storage device tray (A), then secure it
with four (4) screws (B).