User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
32
2.3 Installing the desk mount
Temporarily remove the storage bays (refer to the Left view section for the
location), and place the Embedded Computer on a at stable surface with
its left side facing down as shown.
Align the desk mount with the screw holes on the bottom of the Embedded
Computer, then secure the desk mount to your Embedded Computer using
the bundled screws.
IMPORTANT! When installing the Embedded Computer into a cabinet
or on the ground, we strongly recommend positioning it upright with
the left side facing upwards to allow for optimal heat dissipation.