User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
30
2.2 Installing antennas (optional)
You may install antennas to the antenna jacks located on the front, rear, and
right panels (refer to the Front view, Rear view, and Right view sections for
the locations of the antennas). The installed antennas can be connected to
a 4G LTE module installed in the M.2 B-key slot or the mini PCIe slot, a 5G NR
module installed in the M.2 B-key slot, or to a wireless card installed in the
M.2 E-key (Wi-Fi) slot.
4G module and wireless card
For
Wi-Fi
For
4G
ANT.1
ANT.3 (top)
ANT.6
ANT.2 (bottom)
ANT.5
ANT.4
Ant. Jack Module Module Connector
ANT. 2 Wi-Fi Wi-Fi_Aux
ANT. 4 Wi-Fi Wi-Fi_Main
ANT. 3 4G LTE LTE_Main
ANT. 5 4G LTE LTE_Aux
ANT. 6 4G LTE LTE_GPS