User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
27
2.1.3 Connect a display panel to your Embedded
Computer
You can connect a display panel or projector that has the following
connectors to your Embedded Computer:
• HDMI™
• DisplayPort
To connect an HDMI™ display panel:
Connect one end of the HDMI™ cable to an external display, and the other
end of the cable to your Embedded Computer’s HDMI™ port.
NOTE: If you are using a HDMI™ cable with a locking screw connector,
tighten the lock screw onto the cable lock screw hole on the chassis to
prevent disconnection caused by tension or vibration.
Connect display via HDMI™ port