User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
23
If your Embedded Computer package comes bundled with a power adapter,
you may follow the steps below to set up your Embedded Computer.
A. Connect the power cord to the AC power adapter.
B. Connect the power terminal block to power jack adapter to the AC
adapter.
C. Connect the power terminal block to power jack adapter to your Edge
Computer’s power (DC) input, then secure it with the two screws on the
power terminal block to power jack adapter cable.
D. Plug the AC power adapter into a 100 V - 240 V power source.