User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
22
2.1 Getting started
2.1.1 Connecting a power adapter to your
Embedded Computer
NOTE:
• The power adapter is optional and may not come bundled.
•
The optional power adapter may vary in appearance, depending on
model and country (or region) of sale. Refer to the following for more
information on the power adapter, as well as the system
:
330W Power adapter
Input voltage: 100 - 240 Vac
Input frequency: 50 - 60 Hz
Output current: 13.75 A (330 W)
Output voltage: 24.0 Vdc
Operating temperature : 0˚C to 40˚C
System
Rated input current: 41.25 A - 6.88 A (330 W)
Rated input voltage: 8 - 48 Vdc
Operating temperature : -20˚C to 60˚C
• We suggest using a power supply with 8 - 48 Vdc for DC-in that
complies with the safety requirements of a regulated power source.
IMPORTANT!
• We strongly recommend that you use a grounded wall socket while
using your Embedded Computer.
• The socket outlet must be easily accessible and near your
Embedded Computer.
• To disconnect your Embedded Computer from its main power
supply, unplug your Embedded Computer from the power socket.