User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
18
1.1.3 Right view
Antenna jack
The antenna jack allows you to connect a wireless
antenna. Refer to the Installing antennas section for more
information on installing the antennas.
NOTE: SMA cables, antennas, and wireless modules
are purchased separately.
Antenna jack
The antenna jack allows you to connect a wireless
antenna. Refer to the Installing antennas section for more
information on installing the antennas.
NOTE: SMA cables, antennas, and wireless modules
are purchased separately.
2.5-inch Hot-swap Storage Bay
The 2.5-inch hot-swap storage bay allows you to install a
2.5-inch HDD/SSD and supports RAID 0/1.