User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
15
Antenna jack
The antenna jack allows you to connect a wireless
antenna. Refer to the Installing antennas section for more
information on installing the antennas.
NOTE: SMA cables, antennas, and wireless modules
are purchased separately.
Functional Earth Ground
The functional earth ground provides you with a
grounding point.
Dual-mode DisplayPort
The DisplayPort 1.2 port can support resolutions up to
4096 x 2304 @ 60 Hz on external display devices.
HDMI™ 1.4 port with cable lock
The integrated HDMI (High Denition Multimedia
Interface) port with a receptacle connector can support
resolutions up to 4096 x 2304 @ 30 Hz on external display
devices.
NOTE: The cable lock helps to prevent disconnection
caused by tension or vibration.
DisplayPort
The DisplayPort allows you to connect your Embedded
Computer to an external display.
NOTE:
• This port is only functional when supported by
an optional MXM GPU module.
• When using only this port as a display output
source, this port will support a resolution of up to
4K @ 60 Hz. The resolution may also be aected
by the cabling and output device.