User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
13
USB 10Gbps port with cable lock
The USB (Universal Serial Bus) 10Gbps port provides a
transfer rate up to 10 Gbit/s.
NOTE: The cable lock helps to prevent disconnection
caused by tension or vibration.
Microphone Input jack
The microphone input jack is used to connect your
Embedded Computer to an external microphone.
1G PoE LAN port with cable lock
The 8-pin RJ-45 LAN port supports a standard Ethernet
cable for 10/100/1000 Mbps connection to a local
network, and supports Power over Ethernet (PoE).
NOTE: The cable lock helps to prevent disconnection
caused by tension or vibration.
2.5G PoE LAN port with cable lock
The 8-pin RJ-45 LAN port supports a standard Ethernet
cable for 10/100/1000/2500 Mbps connection to a local
network, and supports Power over Ethernet (PoE).
NOTE: The cable lock helps to prevent disconnection
caused by tension or vibration.
Antenna jack
The antenna jack allows you to connect a wireless
antenna. Refer to the Installing antennas section for more
information on installing the antennas.
NOTE: SMA cables, antennas, and wireless modules
are purchased separately.