User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
12
Serial (COM/CAN) connector (optional)
The 9-pin COM/CAN Bus serial connector allows you
to connect devices with a COM/CAN interface, such
as an electronic control unit (ECU). Please refer to the
table below for the pin deînitions of the COM/CAN Bus
connector.
1 2 3 4 5
6 7 8 9
Pin
CAN Bus
1 NA
2 CAN_L
3 GND
4 NA
5 GND
6 NA
7 CAN_H
8 NA
9 NA
System Reset pinhole
The hard reset pinhole allows you to reboot your
Embedded Computer
External Fan connector with cable lock (reserved)
The external fan connector allows you to connect an
external fan for your Embedded Computer.
NOTE: An external fan option is currently not
available for standard models. If you have a
requirement for this option, please contact your sales
representative.
WARNING! An external fan must be installed with a
fan guard to prevent accidental contact with moving
parts.