User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Installing a storage device
- 3.2 Removing the top heatsink
- 3.3 Replacing the top heatsink
- 3.4 Installing an MXM GPU module
- 3.5 Removing the heat spreader
- 3.6 Installing an M.2 M-key module
- 3.7 Installing an M.2 E-key module
- 3.8 Installing an M.2 B-key module
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing a nano SIM card
- 3.11 Installing memory modules
- Appendix
11
USB 2.0 port with cable lock
The USB (Universal Serial Bus) port is compatible with
USB 2.0 or USB 1.1 devices, such as keyboards, pointing
devices, ash disk drives, external HDDs, speakers,
cameras, and printers.
NOTE: The cable lock helps to prevent disconnection
caused by tension or vibration.
Isolated DIO connector
The Isolated Digital Input/Output (DIO) connector
provides electrical isolation of digital input and output
signals, which allow micro controllers to detect and
output logic states. The high voltage protection can be
used in industrial level uses.
Signal Specications
DO
Output voltage range 0~48 VDC
Rated output current 4 A
DI
Voltage for logic “0” 0~3 VDC
Voltage for logic “1” 10~48 VDC
Rated input current ±50 mA