User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing wall mount brackets
- 3.13 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
PE Series
15
Functional Earth Ground (on selected models)
The Functional Earth Ground provides you with a
grounding point.
Headphone jack
This port allows you to connect amplified speakers or
headphones.
USB 2.0 port (on selected models)
The USB (Universal Serial Bus) port is compatible with
USB 2.0 or USB 1.1 devices, such as keyboards, pointing
devices, flash disk drives, external HDDs, speakers,
cameras, and printers.
Serial (COM/CAN) connector (on selected models only)
The 9-pin RS-232/DB9 serial (COM/CAN) connector
supports the Controller Area Network (CAN) bus protocol
and allows you to connect devices that have serial ports,
such as bar code scanners, modems, or printers. Please
refer to the table below for the pin definitions of the
different COM connectors.
1 2 3 4 5
6 7 8 9
Pin
CAN Bus
1 NA
2 CAN_L
3 GND
4 NA
5 GND
6 NA
7 CAN_H
8 NA
9 NA-