User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing wall mount brackets
- 3.13 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
12
PE Series
LAN port
The 8-pin RJ-45 LAN port supports a standard Ethernet
cable for 10/100/1000/2500 Mbps connection to a local
network.
Activity Link LED
Status Description
Off No link
Green Linked
Green (blinking) Data activity
Green (blinking
then steady)
Ready to wake up
from suspend mode
Speed LED
Status Description
Off
10/100 Mbps
connection
Orange 1 Gbps connection
Green 2.5 Gbps connection
USB 3.2 Gen 2 port
The USB 3.2 Gen 2 (Universal Serial Bus) port provides a
transfer rate up to 10 Gbit/s.
HDMI™ port
The HDMI (High Definition Multimedia Interface) port
supports a Full-HD device, such as an LCD TV or monitor,
to allow viewing on a larger external display.
Dual-mode DisplayPort
This port allows you to connect your Embedded
Computer to an external display and supports DVI or
HDMI™ adapters.
LAN port 1 LED indications
ACT/LINK LED
SPEED LED
LAN port