User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing a wireless card to the M.2 slot
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- 3.16 Installing DIN rail clips (optional)
- Chapter 4: Using the software
- Chapter 5: Watchdog Timer
- Appendix
PE Series
61
3.13 Installing the PoE LAN module
(on selected models)
NOTE:
• The PoE LAN module supports up to 15W per port for powering
IEEE802.3af.
• Operating temperature when using PoE with your device:
-20°C~50°C.
1. Connect the CN1 and CN2 connectors on the PoE LAN module’s
daughter board to the CN1 and CN2 connectors on the PoE LAN
module’s motherboard using the two (2) bundled LAN signal cables.
NOTE: Ensure to connect the CN1 connector on the daughter board
to the CN1 connector on the motherboard, and the CN2 connector on
the daughter board to the CN2 connector on the motherboard.
CN2
CN1
CN1
CN2
motherboard
daughter board