User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing a wireless card to the M.2 slot
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- 3.16 Installing DIN rail clips (optional)
- Chapter 4: Using the software
- Chapter 5: Watchdog Timer
- Appendix
58
PE Series
3.10 Installing the antennas (optional)
1. Remove the rubber caps from the antenna hole.
2. Prepare the RF connector and cable.
3. Insert the antenna jack end of the RF connector and cable into the
antenna hole from within the chassis outwards.
4. Insert the bundled O-ring to the antenna jack, then secure the
antenna jack using bundled hex screw.
5. Connect the other end of the RF connector and cable to your wireless
card or LTE module.
6. Repeat steps 1 to 5 to install additional antennas.
You may install antennas to the four (4) antenna holes located on the front
and rear panels. The installed antennas can be connected to an LTE module
installed in the Mini PCIe/mSATA slot, or to a wireless card installed in the
M.2 Wi-Fi slot.