User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing a wireless card to the M.2 slot
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- 3.16 Installing DIN rail clips (optional)
- Chapter 4: Using the software
- Chapter 5: Watchdog Timer
- Appendix
26
PE Series
7. Power button connector
The Power Button connector allows you to connect an external power
button.
8. Chassis Intrusion connector
The Chassis Intrusion connector allows you to connect a intrusion
sensor or microswitch for the chassis intrusion detection feature. When
you remove any chassis component, the sensor or microswitch triggers
and sends a high level signal and records a chassis intrusion event.
NOTE: By default, a jumper cap that disables the intrusion detection
feature is installed on the connector to prevent accidental triggers.