User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing a wireless card to the M.2 slot
- 3.9 Installing an mPCIe / mSATA module
- 3.10 Installing antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- 3.16 Installing DIN rail clips (optional)
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 Trusted Computing
- 4.4.2 PCH Storage Configuration
- 4.4.3 Onboard Devices Configuration
- 4.4.4 ACPI Settings
- 4.4.5 APM Configuration
- 4.4.6 SMART Settings
- 4.4.7 NCT6116D Super IO Configuration
- 4.4.8 NCT6116D HW Monitor
- 4.4.9 Serial Port Console Redirection
- 4.4.10 CPU Configuration
- 4.4.11 AMI Graphic Output Protocol Policy
- 4.4.12 PCI Subsystem Settings
- 4.4.13 USB Configuration
- 4.4.14 Network Stack Configuration
- 4.4.15 SDIO Configuration
- 4.4.16 Platform Trust Technology
- 4.4.17 Security Configuration
- 4.4.18 Thermal
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Chapter 5: Watchdog Timer
- Appendix
12
PE Series
1.1 Features
1.1.1 Front view
LAN port with PoE (on selected models)
The 8-pin RJ-45 LAN port supports a standard Ethernet
cable for 10/100/1000 Mbps connection to a local
network, and supports Power over Ethernet (PoE). The PoE
LAN module supports up to 15W per port for powering
and complies with IEEE802.3af and CSMA/CD standards
Power button
The power button allows you to turn the Embedded
Computer on or o. You can use the power button to put
your Embedded Computer to sleep mode or press it for four
(4) seconds to force shutdown your Embedded Computer.
LAN port
The Intel I210-AT Gigabit Ethernet controllers with 8-pin
RJ-45 LAN port supports a standard Ethernet cable for
connection to a local network.
USB 3.2 Gen 1 port
The USB 3.2 Gen 1 (Universal Serial Bus) port provides a
transfer rate up to 5 Gbit/s.