User’s Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Edge Computer
- Chapter 2: Using your Edge Computer
- Chapter 3: Upgrading your Edge Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing the Mini PCIe card
- 3.6 Installing a nano SIM card
- 3.7 Installing an SD card
- 3.8 Installing the wireless card
- 3.9 Installing an M.2 SSD
- 3.10 Installing the antennas (optional)
- 3.11 Installing the USB 2.0 module (on selected models)
- 3.12 Installing the Serial port module (on selected models)
- 3.13 Installing the PoE LAN module (on selected models)
- 3.14 Installing the VESA mount (optional)
- 3.15 Installing the wall mount
- Chapter 4: BIOS Setup
- 4.1 Getting to know your BIOS
- 4.2 BIOS setup program
- 4.3 Main Menu
- 4.4 Advanced menu
- 4.4.1 Trusted Computing
- 4.4.2 PCH Storage Configuration
- 4.4.3 Onboard Devices Configuration
- 4.4.4 ACPI Settings
- 4.4.5 APM Configuration
- 4.4.6 SMART Settings
- 4.4.7 NCT6116D Super IO Configuration
- 4.4.8 NCT6116D HW Monitor
- 4.4.9 Serial Port Console Redirection
- 4.4.10 CPU Configuration
- 4.4.11 AMI Graphic Output Protocol Policy
- 4.4.12 PCI Subsystem Settings
- 4.4.13 USB Configuration
- 4.4.14 Network Stack Configuration
- 4.4.15 SDIO Configuration
- 4.4.16 Platform Trust Technology
- 4.4.17 Security Configuration
- 4.4.18 Thermal
- 4.5 Security
- 4.6 Boot menu
- 4.7 Save & Exit menu
- 4.8 Updating your BIOS
- Chapter 5: Watchdog Timer
- Appendix
PE200S Series
109
Watchdog timer Implementation Default Timeout
POST Watchdog Timer
This Watchdog Timer is for recovering
the system from crashes during BIOS
takeover to OS. After system BIOS
takeover, the BIOS will stop the HW
watchdog timer and start the POST
watchdog timer on the same hardware
watchdog circuit.
NOTE: T
he default setting for the
BIOS item is set to enabled.
The timeout value is
determined by the
BIOS settings.
*OS Watchdog Timer
No implementation. User needs to
write software in OS to keep updating
the watchdog timer to prevent it from
timing out. The application is executed
on payload.
NOTE: Please
refer to the
section 4.9.3 Watchdog
Timer Programming for more
information.
N/A