User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing wall mount brackets
- 3.13 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
PE Series
57
3.9 Installingantennas(optional)
You may install antennas to the ve (5) antenna jacks located on the front
and rear panels. The installed antennas can be connected to an LTE module
installed in the Mini PCIe/mSATA slot or to a wireless card installed in the
M.2 Wi-Fi slot.
To install an antenna:
NOTE: If your Embedded Computer came pre-installed with wireless
card antenna jacks, skip to step 8.
1. Remove the bottom cover. Refer to Removing the bottom cover for
details.
2. Prepare the RF connector and cable.
3. Remove the rubber caps from the antenna holes.
4. Insert the antenna jack end of the RF connector and cable into the
antenna hole from within the chassis outwards.