User Manual

76 PE Series
Safetyinformation
Your Embedded Computer is designed and tested to meet the latest
standards of safety for information technology equipment. However,
to ensure your safety, it is important that you read the following safety
instructions.
Setting up your system
• Read and follow all instructions in the documentation before you
operate your system.
• Do not use this product near water or a heated source.
• Set up the system on a stable surface.
• Peripherals with extended tolerance (such as industrial grade mSATA,
and micro SD card) will allow this product to be used in environments
with ambient temperatures between -20˚C and 60˚C, with a 0.1m/s air
ow.
• The product should be used in environments with an ambient
temperature of 60˚C when using the 90 W / 120 W power adapter.
• If you use an extension cord, make sure that the total ampere rating of
the devices plugged into the extension cord does not exceed its ampere
rating.
• This equipment should be installed and operated with a minimum
distance of 20cm between the radiator and your body.
• Restricted Access Location:
The equipment should only be installed in a Restricted Access Area
where both these conditions apply:
– access can only be gained by USERS who have been instructed about
the reasons for the restrictions applied to the location and about any
precautions that shall be taken; and
– access is through the use of a TOOL or lock and key, or other means of
security, and is controlled by the authority responsible for the location.
• This device shall not be connected to an Ethernet network with outside
plant routing.