User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing wall mount brackets
- 3.13 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
66
PE Series
3.13 InstallingDINrailclips(optional)
1. Make sure that the wall mount brackets are already installed. Refer
to the section Installing wall mount brackets for installation
instructions.
2. Align the screw holes on the DIN rail clips to the ones on the wall
mount brackets as shown below.
3. Secure the DIN rail clips to the wall mount brackets using the screws
bundled with the DIN rail clips.
4. Clip the nal assembly to a DIN rail by hooking the DIN rail clips to
the top of the DIN rail and then pressing down until you hear the clips
snap into place.