User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing wall mount brackets
- 3.13 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
PE Series
65
3.12 Installingwallmountbrackets
1. Remove the four (4) rubber feet screws.
2. Align the wall mount with the rubber feet screw holes (A), then
remove the rubber feet from the rubber feet screws (B) and secure the
wall mount brackets to your Embedded Computer using the rubber
feet screws (C).
NOTE: The rubber feet and wall mount screws are the same screws.
Wall Mount Screw
Length: 7.0 mm
Diameter: 7.7 mm