User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing wall mount brackets
- 3.13 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
PE Series
47
To install an M.2 2280 SSD:
1. (optional) If a wireless card is installed, remove the screw holding it in
place (A), replace it with a stando (B), and skip to step 3.
2. (optional) Replace the stando if it was removed.
3. Align and insert the M.2 SSD into its slot inside the Embedded
Computer.
4. Gently push down the M.2 SSD on top of the stando and fasten it
using a screw.