User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing wall mount brackets
- 3.13 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
PE Series
39
2.2 TurningoyourEmbedded
Computer
If your Embedded Computer is unresponsive, press and hold the power
button for at least four (4) seconds until your Embedded Computer turns o.
2.3 PuttingyourEmbeddedComputer
to sleep
To put your Embedded Computer on Sleep mode, press the Power button
once.
2.4 EnteringtheBIOSSetup
BIOS (Basic Input and Output System) stores system hardware settings that
are needed for system startup in the Embedded Computer.
In normal circumstances, the default BIOS settings apply to most conditions
to ensure optimal performance. Do not change the default BIOS settings
except in the following circumstances:
• An error message appears on the screen during the system bootup and
requests you to run the BIOS Setup.
• You have installed a new system component that requires further BIOS
settings or update.
WARNING! Inappropriate BIOS settings may result to instability or boot
failure. We strongly recommend that you change the BIOS settings only
with the help of a trained service personnel.