User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing the VESA mount (optional)
- 3.12 Installing wall mount brackets
- 3.13 Installing DIN rail clips (optional)
- Chapter 4: Watchdog Timer
- Appendix
12
PE Series
LAN port
The 8-pin RJ-45 LAN port supports a standard Ethernet
cable for 10/100/1000/2500 Mbps connection to a local
network.
Activity Link LED
Status Description
O No link
Green Linked
Green (blinking) Data activity
Green (blinking
then steady)
Ready to wake up
from suspend mode
Speed LED
Status Description
O
10/100 Mbps
connection
Orange 1 Gbps connection
Green 2.5 Gbps connection
USB 3.2 Gen 2 port
The USB 3.2 Gen 2 (Universal Serial Bus) port provides a
transfer rate up to 10 Gbit/s.
HDMI
TM
port
The HDMI (High Denition Multimedia Interface) port
supports a Full-HD device, such as an LCD TV or monitor,
to allow viewing on a larger external display.
Dual-mode DisplayPort
This port allows you to connect your Embedded
Computer to an external display and supports DVI or
HDMI
TM
adapters.
LAN port 1 LED indications
ACT/LINK LED
SPEED LED
LAN port