User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing wall mount brackets
- Chapter 4: Watchdog Timer
- Appendix
14
PE Series
Power button
The power button allows you to turn the Embedded
Computer on or off. You can use the power button to
put your Embedded Computer to sleep mode or press it
for four (4) seconds to force shutdown your Embedded
Computer.
Serial (COM) connector
The 9-pin RS-232/RS-422/RS-485/DB9 serial (COM)
connector allows you to connect devices that have serial
ports, such as bar code scanner, modem, or printers.
Antenna hole
The antenna hole allows you to connect a wireless
antenna to enhance wireless signal reception.