User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing wall mount brackets
- Chapter 4: Watchdog Timer
- Appendix
PE Series
13
USB 3.2 Gen 2 port
The USB 3.2 Gen 2 (Universal Serial Bus) port provides a
transfer rate up to 10 Gbit/s.
HDMI™ port
The HDMI (High Definition Multimedia Interface) port
supports a Full-HD device, such as an LCD TV or monitor,
to allow viewing on a larger external display.
Dual-mode DisplayPort
This port allows you to connect your Embedded
Computer to an external display and supports DVI or
HDM™ adapters.
GPIO connector
The 9-pin GPIO (General-purpose Input/Output)
connector allows you to program it for input or output
use, such as lighting control, door control or alarm control.
Pin GPIO
1 DIO_0
2 DIO_4
3 DIO_1
4 DIO_5
5 DIO_2
6 DIO_6
7 DIO_3
8 DIO_7
9 GND
5 4 3 2 1
9 8 7 6