User Manual
Table Of Contents
- About this manual
- Chapter 1: Getting to know your Embedded Computer
- Chapter 2: Using your Embedded Computer
- Chapter 3: Upgrading your Embedded Computer
- 3.1 Removing the bottom cover
- 3.2 Replacing the bottom cover
- 3.3 Installing memory modules
- 3.4 Installing 2.5” storage device
- 3.5 Installing an M.2 SSD
- 3.6 Installing a nano SIM card
- 3.7 Installing a wireless card to the M.2 (E-key) slot
- 3.8 Installing an mPCIe / mSATA module
- 3.9 Installing antennas (optional)
- 3.10 Installing the PoE LAN module (on selected models)
- 3.11 Installing wall mount brackets
- Chapter 4: Watchdog Timer
- Appendix
12
PE Series
System reset pinhole
The hard reset pinhole allows you to reboot your
Embedded Computer.
Power indicator
The power indicator lights up when your Embedded
Computer is turned on and blinks slowly when in sleep
mode.
Drive activity indicator
This indicator lights up when your Embedded Computer is
accessing the internal storage drive.
LAN port
The 8-pin RJ-45 LAN port supports a standard Ethernet
cable for 10/100/1000 Mbps connection to a local
network.
LAN port 1 LED indications
ACT/LINK LED
SPEED LED
LAN port
Speed LED
Status Description
Off 10 Mbps connection
Orange 100 Mbps connection
Green 1 Gbps connection
Activity Link LED
Status Description
Off No link
Yellow Linked
Yellow (blinking) Data activity
Yellow (blinking
then steady)
Ready to wake up
from suspend mode